Calibration board image

Hi!

I tought I'd share this since my EORA scanner didn't come with a calibration board I made one. If someone needs it here's a picture which you can print and glue to a cardboard for instance. It might be good to use as though paper as possible to avoid noise while gluing it to the cardboard.
https://www.dropbox.com/s/zcf0a5j26k2c59m/eora_calib.pdf?dl=0

Best,
Rauno

Rauno, I found my calibration board at the very, very bottom of the box under the foam packing material. Maybe you overlooked yours?

wasn't there unfortunately. I've disassembled the whole box

The only reason I found my calibration board is I was desperate to find a manual somewhere in the box.

Yet another of the "death by a thousand cuts" that is my experience with Eora so far. The YouTube videos are an extremely poor substitute for actual documentation.

For those missing a calibration board, the image file and instructions for printing out the calibration image and using it were posted at the Eora help site today:

http://help.eora3d.com/getting-started/calibrate-yourself  

For those of us whose countries landed on the moon, A4 paper measures 8.27 inches by 11.69 inches. Hopefully, using 8.5" x 11" paper instead won't present a problem.